[Nicko]

Dodge is a good car for those who like speed and agility. But what do you do when your Dodge Charger won't start?

There are a few things that could be causing your car to not start. It could be something as simple as a dead battery or dirty spark plugs. Or, it could be something more serious like a problem with the fuel system.

Moreover, you might be able to fix the problem yourself! Check out this article to learn more about what might be causing your Dodge Charger to not start, and how you can fix it.

Battery Problems



The most probable explanation for why your Charger's engine won't start up or turns over slowly is a weak or dead 12V battery. By conducting a more extensive inquiry and a voltage test on the battery, you can figure out if the starting issue comes from the battery itself. To do this, use a multimeter to check the voltage between the positive and negative poles of the battery, then see how low its acid levels are and how old/worn down it looks overall.

Shop From Amazon
   

                   

Motorcraft Battery - BAGM94RH7800
                   

                   

Deka 9A94R AGM Intimidator Battery
                   
 
                   

Bosch S6588B S6 Flat Plate AGM Battery
                   
In order to test the voltage, disconnect the black, negative terminal from the battery and then attach the red lead of your multimeter to this terminal. Next, touch the other lead of your multimeter to the positive terminal. The needle on the voltmeter should settle between 12 and 13 volts if your battery is functioning properly. If it falls below 12 volts, then it's likely that your battery is the issue.

Once you've identified that your battery is causing problems, you have a few options. You can jumpstart your car by connecting jumper cables to another car with a working battery. Or, you could try charging your battery with a charger or by driving around for a while. If neither of these solutions works, then you'll probably need to replace your battery.

Shop From Amazon
   

                   

AVAPOW Jump Starter 2000A Peak Portable Battery Jump Starter for Car with Dual USB Quick C...
                   
 
                   

MegaXmar Car Battery Jump Starter -1500A Peak 12800mAh,Portable Car Jump Starter for Up to...
                   
   
 
                   

SYPOM Car Jump Starter, 4000A Peak Battery Jump Starter (for All Gas or Up to 10L Diesel),...
                   
Corrosion



Battery corrosion is another common problem that can prevent your car from starting. Corrosion is caused by a build-up of acid on the battery terminals, which can happen if you don't clean them regularly. This build-up of acid prevents electricity from flowing freely between the battery and the starter, causing your car to not start.

In order to determine if your Charger's starting problems are due to dirty battery contacts, you will need to inspect them. If you lift the rubber covers over the two battery terminals, you can check for corrosion on the terminals. If you only see white or silvery-green deposits, and no other cracks or damage, don't replace the battery yet. Just clean it first.

To clean your Dodge Charger's battery, you must remove the pole cables. This task is not difficult and does not require special knowledge, just a little concentration because the order in which you remove the cables is important. Begin by removing the black cable from the negative pole. If necessary, use pliers to loosen a tight clamp before removal. While we don't recommend it if you choose to use metal pliers while piercings, be sure not to touch any other areas of the body.

After you disconnect the red positive pole cable, you can remove the battery from the circuit.  For this purpose, use battery cleaner, a special spray that will help remove deposits on the battery terminals. Simply apply the spray to the damaged areas, allow to work for 15 minutes and remove with a cloth. Once it has been removed, clean any corrosion off of the battery. Once it is clean, reconnect the terminals.